Does anyone have any advice on how to make homemade conductive paint to fix a cracked carbon trace in a game controller?
It's the trace going towards the mode button, so I'm pretty sure resistance won't exactly be critical over a ~3mm gap, as long as it recognizes when the plunger button is pressed down.
You're viewing a single thread.
Copper foil tape
Isn't that only good to block radio frequencies and other interference? Isn't the adhesive still an insulator?
Most copper tape i've seen has conductive adhesive
This is interesting and good to know. I'll try to keep this in mind whenever I get ready to set up shop to finish fixing it, I do have a couple busted phones around and should be able to find a section of copper tape in one of them. 👍
You'll have a bad time with used copper tape. Just like why it isn't advised to reuse any other kind of tape (duct, packaging, electrical)
Hey I hear you there.
I'm still game to give it a try though. Besides, whatever fix I end up going with, I'm still going to cover over that with brand new Kapton tape to protect it.
Worked well to fix my instrument panel in the dashboard of my old truck.
I'll keep that in mind for future experimental reference, but as of right now I don't have any handy.
Thanks for the advice though 👍
For sure! It was pretty cheap but Idk if it will do it for you when its all said and done. Good lick